![]() Feel confident that your purchase will meet, and in most cases, exceed your expectations. We’re proud that only 1.75% of the items shipped are ever returned. Each item has been submitted to local and national law enforcement agencies so you can purchase items ethically and safely.Ĭasa Pawn | Tucson | AZ Merchants get the highest marks in delivery success. We wanted to touch on all the main features, specs and other factors that will help guide you outside of price and promotions that seem to change constantly.Casa Pawn | Tucson | AZ is home to the internet’s best prices and value, the opportunity to negotiate with merchants with “Make Offer”, and a 100% money-back guarantee on all items except for “as-is”.Ĭasa Pawn | Tucson | AZ is like eBay and Amazon’s used good marketplaces but our items come directly from licensed merchants from all over the United States. The intent for the Ohio Power Tool Selecting Guides is always to help you find the Right Tool for the Job and application. ![]() For other applications where you need to drill hundreds of holes, when the speed and bit life are going to be bigger factors, it makes more sense and in the end saves you money going with a more expensive bit from the start. For some applications, they will use a fresh bit, drill a few holes, and who knows when they’ll need it again? For those uses you can just grab the cheapest bit you can find. Often time, our customers prefer to purchase 2-cutter carbide and full head 4-cutter bits in bulk to accommodate a variety of different jobs and applications. We sell several different brands and options for SDS-Plus, SDS-Max and Spline carbide bits for various reasons. ![]() It’s certainly possible that there could be differences in longevity and speed as the bit wears a little more, but considering that they are produced by the same parent company, we highly doubt there will be much of a noticeable performance difference. However, that is not exactly the case.Īs you can see with the 3/8” diameter, they do have a slightly different Full Head Carbide configuration, but we’ve done some initial testing and have seen that there is nothing too noticeably different in speed with the new bit. Carbide bits from both brands are produced in a factory owned by the parent company in Germany, so naturally we initially thought that they were the exact the same bits– Bosch Blue stickers going to one box chain store and Diablo Red going to another box chain store, same bits…different color. The Freud/Diablo Brands are owned by Parent Company The Bosch Group, which of course is also the same parent company for The Robert Bosch Tool Corporation. Certainly they make 2-cutter carbide in larger ¾” or 1” sizes, but at that point it’s just to lower the upfront price–performance will be much slower and they will not last as long, so we’d recommend staying away from them if you can. 4-cutter full head carbide, but the full head will have even better performance and an even longer life. You’ll still have the option of 4-cutter slotted vs. The larger you get, the faster the speed, lower the heat and longer the life due to the cross design of the bit. When you get to 1/2” and larger carbide bits in either SDS-Plus, SDS-MAX or Spline, you ideally should be going to a 4-cutter cross geometry. The smaller Bosch Full Carbide “Bulldog Xtreme” bits, for instance, are basically a solid 2-cutter full head carbide, and from what we have seen with thousands of bits sold, these have performed the best out of all of the smaller diameters up to this point. That’s not to say that there aren’t faster, better, longer lasting bits, certainly there are better ones, but the number of cutter points means less the smaller you go. With smaller size carbide bits (under 1/2″), SDS-Plus and SDS-Max 2-cutter vs 4-cutter matters less and less in terms of speed–there’s just not that much surface area to work with.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |